Pundit, technological control system can help some fine polishing the implementation artifacts of batch production. Fine polishing is the most essential in the process of product appearance parts processing procedure. Before the workpiece spray paint, anode, electroplating, etc, all need grinding polishing to remove surface defects, improve the surface consistency, increase the adhesion; Although now more and more factories begin to use robots to carry on the automatic grinding and polishing, but on the market at present most artificial buffing, in addition to because the upfront cost is higher, more is unable to realize automation of mass production; Sheet metal, box, plastic and other industries, for example, the workpiece itself will tolerance is bigger, a manipulator with two sets of workpiece grinding test is no problem, to be able to debug out; Is the lack of a flexible manipulator itself, however, can only be run according to teach good fixed path, once put into batch production, need frequent replacement of artifacts, dimensional tolerance, between each artifact will make or grinding, or not polished, lead to yield very poor, production costs have risen sharply, the enterprise can't afford to; If using the
Force Control System, its active adaptation, according to the size of the difference between artifacts, instantaneous adjustment, and can control within the scope of the need, to ensure the consistency between polishing effect, production yield can be guaranteed.
